Mazda CX-5 Service & Repair Manual: Instrumentation/Driver Info. Personalization
-
A personalization function has been adopted which enables the instrument cluster settings to be changed.
-
The Mazda Modular Diagnostic System (M-MDS) is required to perform the setting. Refer to the Workshop Manual for the detailed setting procedure.
Instrument cluster
|
Mazda Modular Diagnostic System (M-MDS) display |
Function |
Initial setting |
Setting contents |
Control unit |
|
Lights-on Reminder Volume. |
The volume for the lights-on reminder warning alarm can be changed. |
High |
Not Adopted. / OFF / Low / High |
Instrument cluster |
|
Turn Signal Volume. |
The volume of the turn and hazard indicator alarm can be changed. |
High |
Not Adopted. / Low / High |
Instrument cluster |
Blind Spot Monitoring (BSM) System
|
Mazda Modular Diagnostic System (M-MDS) display |
Function |
Initial setting |
Setting contents |
Control unit |
|
BSM Volume. |
The volume of the blind spot monitoring (BSM) warning alarm can be changed. |
High |
Not Adopted. / OFF / Low / High |
Instrument cluster |
Instrumentation/Driver Info.
Outline
An LCD has been adopted to the instrument cluster which displays the ambient
temperature, trip computer, and odometer/tripmeter.
A blind spot monitoring (BSM) system has been ...
Instrumentation/Driver Info. Personalization Features Setting Procedure
1. Connect the M-MDS to the DLC-2.
2. After vehicle identification, select the following from the M-MDS initialization
screen.
a. “Module programming“
b. “Programmable Parameters”
3. ...
Other materials:
Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with
the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto
tensioner is within the normal range.
If ...
Electric Variable Valve Timing Actuator Inspection
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
CAUTION:
Do not disassemble the electric variable valve timing actuator because it
is a precision unit.
1. Disconnect the negative battery cable..
2. Remo ...
Roof Molding Removal
1. Insert a tape-wrapped flathead screwdriver in the position shown in the figure.
2. Rotate a tape-wrapped flathead screwdriver in the direction of the arrow in
the order of (1), (2) shown in the figure and remove the roof molding from the front
T-stud.
3. Rotate the roof molding in th ...
