Mazda CX-5 Service & Repair Manual: Driver Info & Control

Theft Deterrent Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). 3. Disconnect the connector. 4. Remove t ...

General

...

Other materials:

Liftgate Opener Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. d. Liftgate garnish. e. Liftgate opener switch. 3. Verify the continuity of liftgate opener switch terminals B and C. If not as i ...

Oil Seal (Differential) Replacement [Fw6 A EL, Fw6 Ax EL]
Transaxle Case Side 1. Remove the front under cover No.2.. 2. Drain the ATF.. 3. Disconnect the drive shaft (LH) from the transaxle.. CAUTION: The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal. 4. Remove ...

Filament Repair
1. Clean the filament using isopropyl alcohol. 2. Attach tape to both sides of the filament. 3. Using a small brush or marking pen, apply silver paint. 4. After 2—3 min, carefully remove the tape without damaging the applied area. CAUTION: Do not operate the rear window defro ...