Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Instrumentation/Driver Info. Personalization Features Setting Procedure

Mazda CX-5 Service & Repair Manual / Body / Driver Info & Control / General / Instrumentation/Driver Info. Personalization Features Setting Procedure

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

a. “Module programming“

b. “Programmable Parameters”

3. Select menu in the “IC”.

4. Select an item name, and than select option.

Instrument cluster


Mazda Modular Diagnostic System (M-MDS) display

Function

Initial setting

Setting contents

Control unit

Lights-on Reminder Volume.

The volume for the lights-on reminder warning alarm can be changed.

High

Not Adopted. / OFF / Low / High

Instrument cluster

Turn Signal Volume.

The volume of the turn and hazard indicator alarm can be changed.

High

Not Adopted. / Low / High

Instrument cluster


Blind Spot Monitoring (BSM) system


Mazda Modular Diagnostic System (M-MDS) display

Function

Initial setting

Setting contents

Control unit

BSM Volume.

The volume of the Blind Spot Monitoring (BSM) warning alarm can be changed.

High

Not Adopted. / OFF / Low / High

Instrument cluster


Instrumentation/Driver Info. Personalization
A personalization function has been adopted which enables the instrument cluster settings to be changed. The Mazda Modular Diagnostic System (M-MDS) is required to perform the setting ...

Liquid Crystal Display (LCD)
Outline The LCD displays vehicle information in the instrument cluster. The instrument cluster performs LCD fail-safe.. Function/Construction The instrument cluster configu ...

Other materials:

Front Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the front accessory socket i ...

Fog Lights
Use this switch to turn on the fog lights. The fog lights will improve visibility at night and during foggy conditions. To turn the fog lights on, rotate the fog light switch to the position. The headlight switch must be in the position before turning on the fog lights. To turn the fog lig ...

Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear scuff plate. b. Trunk end trim. c. Trunk side trim. d. C-pillar trim. e. D-pillar trim. f. Liftgate. 3. Remove fasteners. 4. While partially peeling back the rear part of the headliner, remove nut ...

© 2016-2026 Copyright www.mcx5.org