Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Control System [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Control System [Full Auto Air Conditioner]

Outline

Structural View


System Wiring Diagram


Condenser Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim (LH). c. Rear scuff plate (LH). d. Trunk side trim (LH). e. D-pillar trim (LH). ...

Control System [Manual Air Conditioner]
Outline Refrigerant pressure sensor adopted in which refrigerant pressure is changed into a linear electric signal and precise information is transmitted. Climate control unit wi ...

Other materials:

Front Brake (Disc) Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. 4. Depress the brake pedal a few times, rotate the wheel by hand, and verify that the brake does not drag. ...

Sunroof Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the front map light.. 3. Verify that the continuity between the sunroof switch terminals is as indicated in the table. If not as indicated in the table, replace the sunroof switch. ...

Blind Spot Monitoring (BSM) System
Blind Spot Monitoring (BSM) System The Blind Spot Monitoring (BSM) system is designed to assist the driver by monitoring blind spots on both sides of the vehicle to the rear in certain situations such as when changing lanes on roads and freeways. The BSM system monitors the detection areas on ...

© 2016-2023 Copyright www.mcx5.org