Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake Fluid Pressure Sensor

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Brake Fluid Pressure Sensor

Purpose/Function

Construction

Fail-safe


DTC No.

Fail-safe function

C0044:01

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.)

  • Inhibits the TCS*, DSC*, roll over mitigation (ROM)*, brake assist control, hill launch assist (HLA)*, and TPMS* controls.

C0044:28

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes.

  • Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.

C0044:54

C0044:64

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.)

  • Inhibits the TCS*, DSC*, roll over mitigation (ROM)*, brake assist control*, hill launch assist (HLA)*, and TPMS* controls.


* Enabled depending on malfunction content.

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection
CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. 3. T ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Other materials:

Manual Transaxle Shift Mechanism Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Remove the shift lever using the following procedure: a. Remove the upper panel.. b. Remove the shift lever knob. c. Remove the shift panel.. d. Remove the side wall.. e. Remove the rear console.. f. Press the tabs on the control cable ...

Differential Oil Temperature Sensor Inspection
WARNING: Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is hot. 1. Disconnect the negative battery cable. 2. Disconnect the differential oil temperature sensor connector and remove the differential oil temperature sensor. 3. Wrap ...

Drive Plate Removal/Installation [Fw6 A EL, Fw6 Ax EL]
1. Remove the transaxle.. 2. Remove in the order indicated in the table. 1 Drive plate installation bolts (See Drive Plate Installation Bolts Removal Note.) (See Drive Plate Installation Bolts Installation Note.) 2 Backing plate ...

© 2016-2026 Copyright www.mcx5.org