Mazda CX-5 Service & Repair Manual: Intake Manifold
Purpose, Function
-
Distributes intake air to each cylinder evenly.
-
Optimizes the combustion efficiency and performance of the engine by distributing intake air to each cylinder.
Construction
-
The intake manifold is installed to the cylinder head.
Intake Manifold Vacuum Inspection
1. Disconnect the evaporative hose No.3 (purge solenoid valve side) and install
the vacuum gauge..
2. Verify that the intake air hoses are installed securely.
3. Warm up the engine.
4. Measure ...
Manifold Absolute Pressure (Map) Sensor Inspection
Voltage Inspection
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification..
...
Other materials:
Shift Lever [C66 M R]
Purpose, Function
The shift lever operates the MTX via the control cable.
Construction
Shift lever
The shift lever is designed to prevent improper shifting to 1st gear and
reverse.
Operation
1 GR shifting
A guide plate, attached to the shift lever assembly, ...
Front Seat Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both side ...
Center Roof Antenna Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Front seat belt adjusting cover.
e. Front seat belt upper anchor installation bolt.
f. B-pillar upper trim.
g. Trunk board.
h. Trunk end t ...
