Mazda CX-5 Service & Repair Manual: Battery

Relay And Fuse Block Removal/Installation

1. Remove the battery tray.. 2. Remove the air cleaner case.. 3. While pressing the relay and fuse block upper cover tab in the direction of the arrow (1) shown in the figure, lift up the relay ...

Battery Inspection [Skyactiv G 2.0]

WARNING: Since battery acid is toxic, be careful when handling the battery. Since battery acid is highly corrosive, be careful not to allow it to contact clothing or the vehicle. ...

Other materials:

Upper Cowl Side Reinforcement Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 13 locations indicated by (A) shown in the figure. 2. Drill the 8 locations indicated by (B) shown in the figure. NOTE: When a drill the 8 locations indicated by (B) shown in the figure, the through hole is not made in consideration of ...

M Position Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection NOTE: The M position switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the selector lever component connector. 4. Verify that the continuity between selector lever c ...

Accelerator Pedal Position (App) Sensor Inspection
Voltage Inspection NOTE: Because the APP sensor is integrated in the accelerator pedal, replacing the APP sensor includes replacement of the accelerator pedal. 1. Connect the M-MDS to the DLC?2. 2. Switch the ignition ON (engine off or on). 3. Verify that the APP sensor output ...