Mazda CX-5 Service & Repair Manual: ABS
- ABS Control
- ABS Wheel Speed Sensor And ABS Sensor Rotor
- Brake System/ABS Warning Light
- Front ABS Wheel Speed Sensor Inspection
- Front ABS Wheel Speed Sensor Removal/Installation
- Rear ABS Wheel Speed Sensor Inspection [2 Wd]
- Rear ABS Wheel Speed Sensor Inspection [Awd]
- Rear ABS Wheel Speed Sensor Removal/Installation
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
ABS Control
Outline
ABS control occurs when wheel slip is determined by the DSC CM (based on
the four ABS wheel-speed sensors). Then, the DSC HU inlet and outlet solenoid
valves are operated and brak ...
Other materials:
Torque Sensor
Purpose/ Function
The torque sensor detects the steering torque and the steering direction,
and outputs the signal to the Electric Power Steering (EPS) control module (CM).
Construction, Operation
The Hall IC-type torque sensor is installed to the top of the steering column
...
Rear Door Quarter Glass Removal/Installation
1. Fully lower the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the rear door weather strip arrow (1) shown in the figure.
5. Remove the service hole cover No.1 arrow (2) shown in the figure.
CAUTION:
When removing service ...
Steering Angle Sensor Inspection
1. Remove the column cover..
2. Connect the plus (+) end of a tester to steering angle sensor terminal A and
the minus (-) end of the tester to terminal B (GND).
3. Switch the ignition ON (engine off or on).
4. Turn the steering wheel to the left and right.
5. Verify that the voltage f ...
