Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Windshield Wiper Motor

Purpose

Function

Construction


Operation

1. The current flowing from the front body control module (FBCM) is input to the magnet and the motor shaft connected to the armature is rotated.

2. The rotation force of the motor shaft is transmitted to the wheel gear via the worm connected to the motor shaft to drive the windshield wiper link.

3. The windshield wiper link converts the rotation force of the windshield wiper motor to a horizontal reciprocating movement to drive the windshield wiper arms and blades.

4. If the windshield wiper arms and blades are operated to the park position, the auto stop switch turns on by contacting the contact point of the cam plate to stop windshield wiper arms and blades at the park position.

Fail-safe

Windshield Wiper Arm And Blade Removal/Installation
Windshield Wiper Arm 1. Open the hood. CAUTION: If excessive force is applied when removing the cap, tabs could break. Carefully remove the cap. 2. Insert a tape-wrapped precision ...

Windshield Wiper Motor And Link Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Windshield wiper arm and blade. b. Cowl grille. CAUTION: Always affix protective tape to the windshield end ...

Other materials:

Bumper Bracket Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Rough cut area locations indicated by (A). 2. Grind the 6 locations indicated by (B) shown in the figure. CAUTION: When grinding 6 locations indicated by (B) shown in the figure and the front side frame is damaged, there is a possibility that ...

A/C Compressor Control [Full Auto Air Conditioner]
Purpose The A/C compressor control switches the A/C compressor on/off according to the vehicle environment. Function The A/C compressor control turns the A/C compressor on/off based on the climate control unit operation and signals from each sensor. The A/C compress ...

Rear Body Control Module (Rbcm) Removal/Installation
CAUTION: If configuration is not performed when the rear body control module (RBCM) is replaced with a new one, the vehicle specification information is not stored in the rear body control module (RBCM) and the system will not operate normally. When performing configuration, it ...

© 2016-2021 Copyright www.mcx5.org