Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Throttle Position (TP) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Control / Throttle Position (TP) Sensor

Purpose/Function

Construction

Operation

TP sensor characteristic


Fail-safe


DTC No.

Fail-safe function

P0122:00

  • Restricts the upper limit of the engine speed.

P0123:00

  • Restricts the upper limit of the engine speed.

P0222:00

  • Restricts the upper limit of the engine speed.

P0223:00

  • Restricts the upper limit of the engine speed.

P2101:00

  • Restricts the upper limit of the engine speed.

  • Stops the drive-by-wire control (throttle valve is open at approx. 8° by return spring force).

P2109:00

  • Restricts the upper limit of the engine speed.

  • Stops the drive-by-wire control (throttle valve is open at approx. 8° by return spring force).

P2135:00

  • Restricts the upper limit of the engine speed.

  • Stops the drive-by-wire control (throttle valve is open at approx. 8° by return spring force).


Throttle Position (TP) Sensor Inspection
Voltage Inspection CAUTION: The inspection cannot be performed with this method correctly if there is a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs rel ...

Accelerator Pedal Position (App) Sensor Inspection
Voltage Inspection NOTE: Because the APP sensor is integrated in the accelerator pedal, replacing the APP sensor includes replacement of the accelerator pedal. 1. Connect the M-MDS t ...

Other materials:

Front Door Removal/Installation
WARNING: Removing the front door without supporting it could cause the front door to fall and cause serious injury. Always perform the procedure with at least one other person to prevent the front door from falling. CAUTION: When the front door checker securing bolts are ...

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation
NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Disconnect the negative battery cable.. 2. Disconnect the MAP sensor/IAT sensor No.2 connector. 3. Remove the MAP sensor/IA ...

Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear scuff plate. b. Trunk end trim. c. Trunk side trim. d. C-pillar trim. e. D-pillar trim. f. Liftgate. 3. Remove fasteners. 4. While partially peeling back the rear part of the headliner, remove nut ...

© 2016-2026 Copyright www.mcx5.org