Mazda CX-5 Service & Repair Manual: Rear Side Panel Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 11 locations shown in the figure.
2. Remove the rear side panel.
Rear Side Panel Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before inst ...
Rear Spoiler Removal/Installation
Removal
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
1. Remove the liftgate upper trim.
2. Remove caps A.
3 ...
Other materials:
Fuse Block
Purpose
Fuses used by each system are grouped and housed together for smooth inspection
and replacement servicing.
Function
Fuses used by each system are grouped and housed together.
Construction
Installed inside the front side trim (LH).
Operation
Fu ...
Oil Filter
Purpose, Function
Engine oil is filtered by passing engine oil through the oil filter element.
Construction
The oil filter is installed on the right side surface of the cylinder block.
A spin-on type (full-flow type) oil filter has been adopted.
The bypa ...
Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Drain the engine coolant..
4. Pull out the evaporati ...
