Mazda CX-5 Service & Repair Manual: Body Exterior, Frame

Rear Door Trim Removal/Installation

1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 2. Remove the screw C. ...

General

...

Other materials:

Rear Drive Shaft Inspection
1. Inspect each connecting part for looseness. Tighten or replace parts if necessary. 2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease, and looseness in the boot band. 3. Inspect the drive shaft for bends, cracks, and wear in the joints or splines. ...

Rear Center Seat Belt Removal/Installation
CAUTION: The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor. 1. Press the release switch, then dis ...

Clock Spring Inspection [Standard Deployment Control System]
1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Remove the steering wheel.. 4. Remove the column cover.. 5. Remove the clock spring.. 6. Verify that the continuity is as indicated in the table. If not as indicated ...