Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Side Panel Installation [Panel Replacement]

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame / General / Rear Side Panel Installation [Panel Replacement]

Symbol Mark


Installation Procedure

1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions.

2. Drill holes for the plug welding before installing the new parts.

3. After temporarily installing new parts, make sure the related parts fit properly.

4. Plug weld the 11 locations shown in the figure, then install the rear side panel.


Rear Sash Molding Removal
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. 1. Remove the rear door garnish. (rear side). 2. Remove the double-si ...

Rear Side Panel Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 11 locations shown in the figure. 2. Remove the rear side panel. ...

Other materials:

Key Cylinder Switch
Purpose The switch turns on/off in conjunction with the front door key cylinder lock/unlock and the rear body control module (RBCM) detects the key cylinder operation condition by the change in the voltage. Function The key cylinder switch contact point changes in conjuncti ...

Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder. 2. Inspect for continuity according to fluid level between the brake fluid level sensor terminals. If not as indicated in the table, replace the reserve tank.. ...

Service Cautions
Injury/damage Prevention Precautions Depending on the vehicle, the cooling fan may operate suddenly even when the ignition is switched to off. Therefore, keep hands and tools away from the cooling fan even if the cooling fan is not operating to prevent injury to personnel or damage t ...

© 2016-2026 Copyright www.mcx5.org