Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Bumper Disassembly/Assembly

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame / General / Rear Bumper Disassembly/Assembly

1. Disassemble in the order indicated in the table.



1

Screw

2

Reflector

3

Rear bumper face


2. Assemble in the reverse order of disassembly.

Rear Beltline Molding Removal/Installation
CAUTION: Affix protective tape to the position shown in the figure. 1. Fully open the rear door glass. 2. Insert a tape-wrapped flathead screwdriver and then detach the clip A in ...

Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear splash shield. b. Rear combination light. c. Rear bumper. 3. Remove the hanger rubber in the direction of th ...

Other materials:

Hood
WARNING Always check that the hood is closed and securely locked: A hood that is not closed and securely locked is dangerous as it could fly open while the vehicle is moving and block the driver's vision which could result in a serious accident. Opening the Hood 1. With the vehicle parke ...

Clock Spring Removal/Installation [Standard Deployment Control System]
CAUTION: If the disc on the combination switch is deformed or has foreign material adhering to it, performance of the steering angle sensor may be reduced, causing abnormal operation. When handling the clock spring, be careful not to deform the disc and make sure there is no foreign ...

Shift Point Control (Automatic Shift Control) [Fw6 A EL, Fw6 Ax EL]
Outline The TCM implements auto shift control according to the vehicle speed and accelerator pedal depression amount while in D position. When the vehicle is stopped with the selector lever is in the D position and the brake pedal depressed, the neutral idle control is performed ...

© 2016-2026 Copyright www.mcx5.org