Mazda CX-5 Service & Repair Manual: Manual Transaxle [C66 M R]
Purpose, Function
-
The MTX converts the drive force (speed, torque, rotation direction) input from the engine according to the shift lever operation inside the vehicle.
Construction
Operation
Manual Transaxle Shift Mechanism Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Remove the shift lever using the following procedure:
a. Remove the upper panel..
b. Remove the shift lever knob.
c. Remove the shift panel.. ...
Neutral Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Remove the air cleaner component. (ex: air cleaner, air hose).
3. Remove in the order indicated in the table.
4. Install in the reverse order of rem ...
Other materials:
Starter Cut Off Control [Skyactiv G 2.0]
Outline
The PCM controls energization to the starter relay according to an immobilizer
system request to improve security.
While not in P or N position, the starter relay energization by the ignition
key is inhibited. (ATX)
While not in neutral, the starter relay energiz ...
Hood Adjustment
Height Difference Adjustment
1. Verify that the height difference between the hood and the body is within
the specification.
Standard clearance
a: 2.7—6.9 mm {0.11—0.27 in}
b: 4.1—8.0 mm {0.17—0.31 in}
2. Disconnect the negative battery cable..
3. Remove the ...
B Pillar Upper Trim Removal/Installation
1. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Adjuster anchor cover.
e. Upper anchor installation bolts on the front seat belt.
2. Partially peel back the seaming welt.
3. Take the shaded area shown in the figure, and pull the B-pi ...
