Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Ion Sensor Inspection

DTC Inspection

1. Connect the M-MDS to the DLC?2.

2. Perform the DTC inspection using the M-MDS..

Visual Inspection

NOTE:

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove the ignition coil/ion sensor..

4. Verify that there is no damage to the ignition coil/ion sensor, and no corrosion and damage to the connector.

Inspection Of SST (Deployment Tool) [Two Step Deployment Control System]
1. Before using the SST (49 H066 002), inspect its operation. Inspection Procedure 1. Follow the steps below to inspect the SST (49 H066 002). If not as indicated in the table, repl ...

Ion Sensor
Purpose/Function Detects ion generation in the combustion chamber for detecting pre-ignition. Detects ions which occur due to fuel combustion as current by applying bias voltage to t ...

Other materials:

Power Seat System
Outline The power seat system drives the electric motor, operates the front seat safely, and changes the driving posture to suit the occupant by operating the power seat switch. 8 way power seats or 6 way power seats have been adopted on the driver's seat. Function ...

Driver Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. NOTE: The driver-side air bag module is installed to the ...

Corner Junction Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

© 2016-2026 Copyright www.mcx5.org