Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Ignition / Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Connector

2

Ignition coil


Ignition Coil [Skyactiv G 2.0]
Purpose, Function The ignition coil generates high voltage by electromagnetic induction to discharge the spark plug. Construction The ignition coil is installed to the upper par ...

Ignition System [Skyactiv G 2.0]
Outline A direct ignition coil for independent ignition control has been adopted. An ignition coil built-into the ion sensor has been adopted. An iridium spark plug has been ado ...

Other materials:

Blower Unit
Purpose The blower unit switches between fresh air and recirculated air (FRESH/REC) and sends airflow into the cabin. Function Air is blown by the blower motor in the blower unit. The blower unit switches the air intake port to FRESH or REC based on the position of ...

Main Silencer
Purpose, Function Reduces the exhaust noise. Construction The main silencer is installed to the vehicle rear, under the trunk compartment. 2WD AWD The main silencer consists of the filters, holder, set plates and stiffener. ...

Filament Inspection
1. Switch the ignition ON (engine off). 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the tester could damage it. Wrap aluminum foil around the end of the lead and inspect the filament by touching it ...

© 2016-2026 Copyright www.mcx5.org