Mazda CX-5 Service & Repair Manual: Ignition
- Electronic Spark Advance Control [Skyactiv G 2.0]
- Forced Ignition On
- Fuel Distributor [Skyactiv G 2.0]
- Igniter Removal/Installation
- Ignition Coil Inspection [Skyactiv G 2.0]
- Ignition Coil [Skyactiv G 2.0]
- Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]
- Ignition System [Skyactiv G 2.0]
- Spark Plug Inspection [Skyactiv G 2.0]
- Spark Plug Removal/Installation [Skyactiv G 2.0]
- Spark Plug [Skyactiv G 2.0]
Power Supply Switching
Outline
By pressing the push button start, switching of the power supply is performed.
Function
The start stop unit switches the power supply according to the vehicle conditions
...
Electronic Spark Advance Control [Skyactiv G 2.0]
Outline
Controls ignition to optimum timing according to engine operation conditions.
Serviceability has been improved by eliminating the necessity of ignition
timing adjustment.
...
Other materials:
Starter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Remove the starter interlock using the following procedure:
a. Detach hook A in the direction of the arrow shown in the figure.
b. Slide the starter interlock switch in the direction of th ...
Differential Oil Replacement
1. Place the vehicle on level ground.
2. Remove the filler plug.
3. Remove the drain plug and drain the differential oil into a container.
4. Install a new washer and the drain plug, and tighten.
Tightening torque
40—53 N·m {4.1—5.4 kgf·m, 30—39 ft·lbf}
5. Add the ...
Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
If the operation condition is not normal, replace the air intake actuator.
...
