Mazda CX-5 Service & Repair Manual: Spark Plug Removal/Installation [Skyactiv G 2.0]
CAUTION:
-
If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing.
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the ignition coils..
4. Remove the spark plugs using a plug-wrench.
5. Install in the reverse order of removal.
-
Tightening torque
-
15—20 N·m {1.6—2.0 kgf·m, 12—14 ft·lbf}
Spark Plug Inspection [Skyactiv G 2.0]
Specification
Spark plug type
PE01-18110, PE02-18110
Plug Gap Inspection
CAUTION:
To avoid possible damage to the tip, do not adjust the plug gap.
To prevent damaging t ...
Spark Plug [Skyactiv G 2.0]
Purpose, Function
The spark plug generates spark, ignition of the air-fuel mixture occurs,
and combustion of the air-fuel mixture is triggered.
Construction
The spark plug is in ...
Other materials:
Purge Solenoid Valve Inspection
Airflow Inspection
1. Disconnect the negative battery cable..
2. Remove the purge solenoid valve..
3. Inspect airflow between the ports under the following conditions.
Measured condition
Continuity between ports A—B
When voltage is not ...
Glass Antenna
Purpose, Function
The RDS (Radio Data System) converts radio broadcast waves to electric signals
and sends the signals to the audio unit.
Construction
An antenna with excellent noise resistance has been adopted to the rear window
glass.
Fail-safe
Function n ...
PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “BSML” or “BSMR”.
3. Select the applicable PID from the PID table.
4. Ve ...
