Mazda CX-5 Service & Repair Manual: Heated Oxygen Sensor (HO2 S)
Purpose/Function
-
Detects the oxygen concentration (theoretical air/fuel ratio) in the exhaust gas as basic information for mainly determining the fuel injection amount and as information for determining the deterioration of catalytic converter.
-
Detects the oxygen concentration (theoretical air/fuel ratio) in the exhaust gas and inputs it to the PCM as an oxygen concentration (theoretical air/fuel ratio) signal.
Construction
-
Installed to the exhaust manifold.
-
A zirconia element has been adopted as the detecting element for detecting the oxygen concentration (theoretical air/fuel ratio).
Operation
-
Inputs the signal, which fluctuates according to the oxygen concentration (theoretical air/fuel ratio), to the PCM.
HO2S characteristic
Fail-safe
|
DTC No. |
Fail-safe function |
|
P0037:00 |
|
|
P0038:00 |
|
Heated Oxygen Sensor (HO2 S) Removal/Installation
WARNING:
A hot engine and exhaust system can cause severe burns. Turn off the engine
and wait until they are cool before removing the exhaust system.
CAUTION:
Do not allow fla ...
Intake Air Temperature (Iat) Sensor Inspection
IAT Sensor No.1
Resistance inspection
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No ...
Other materials:
Lumber Support Motor Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both side ...
Front Seat Cushion Trim Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both side ...
Starter Interlock Switch Inspection [Skyactiv G 2.0]
CAUTION:
Do not reuse the starter interlock switch if it is removed from the vehicle
even once. Replace with a new starter interlock switch when installing.
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Verify that the contin ...
