Mazda CX-5 Service & Repair Manual: Fuses & Junction Blocks

Remote Transmitter Battery Voltage Inspection

NOTE: Because the remote transmitter battery power cannot be determined using the battery itself, determine by the remote transmitter battery low warning operation conditions. Oper ...

Corner Junction Installation [Panel Replacement]

Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before inst ...

Other materials:

Auto Dimming Mirror Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the screw B. 3. Remove the auto-dimming mirror in the direction of arrow (1) shown in the figure. 4. Detach tabs while push the cover No.2 in the direction of the arrow (2) shown in the figure, then remove the cover No.2 in the d ...

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...

Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial learning has not been implement ...