Purpose
The evaporator temperature sensor detects the airflow temperature passing through the evaporator.
Function
The evaporator temperature sensor converts the detected temperature to an electric signal.
Construction
A thermistor-type evaporator temperature sensor has been adopted.
A fin-thermo-type sensor has been adopted to the sensor area of the evaporator temperature sensor which inserts between the evaporator fins.
The evaporator temperature sensor is installed to the A/C unit.
Operation
The thermistor changes the resistance according to the surrounding temperature.
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.

Fail-safe
Function not equipped.
Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
Evaporator Temperature Sensor [Manual Air Conditioner]Rear Lower Arm Removal/Installation
WARNING:
Be careful not to allow the coil spring to fly off when removing/installing
the coil spring. Otherwise, the coil spring could fly off and cause serious
injury or death, or damage to the vehicle.
1. When working on the left side of the vehicle, disconnect the auto lev ...
Generator Control [Skyactiv G 2.0]
Outline
Idling stability has been improved by optimum control of generator voltage
according to engine operation and electrical load conditions.
The PCM determines the engine operation and electrical load conditions based
on the input signals from each control part and controls ...
M Position Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The M position switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever c ...