Purpose
The evaporator temperature sensor detects the airflow temperature passing through the evaporator.
Function
The evaporator temperature sensor converts the detected temperature to an electric signal.
Construction
A thermistor-type evaporator temperature sensor has been adopted.
A fin-thermo-type sensor has been adopted to the sensor area of the evaporator temperature sensor which inserts between the evaporator fins.
The evaporator temperature sensor is installed to the A/C unit.
Operation
The thermistor changes the resistance according to the surrounding temperature.
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.

Fail-safe
Function not equipped.
Evaporator Temperature Sensor [Full Auto Air Conditioner]Meter Hood Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the upper column cover.
3. Using a phillips screwdriver, remove fasteners.
NOTE:
When pulling up the shaft of fasteners using a phillips screwdriver, the
shaft will not be pulled up if it is rotated by pressing the driver. To pull ...
Side Step Molding Removal/Installation
1. Set the rear over fender aside..
2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove
the clip A in the direction of arrow (1).
3. Slide the side step molding in the direction of the arrow (2) shown in the
figure and remove clips B from side step molding.
4. ...
Instrument Cluster Removal/Installation
CAUTION:
If configuration is not performed when the instrument cluster is replaced
with a new one, the vehicle specification information is not stored in the instrument
cluster and the system will not operate normally.
When performing configuration, it is necessary to read the ...