Mazda CX-5 Service & Repair Manual: Check Fuel Cap Warning Light
Purpose/Function
-
The check fuel cap warning light is built into the instrument cluster.
-
If the PCM detects that the fuel cap is open, the light illuminates to warn the driver that the fuel cap is open.
Construction
-
Built into the instrument cluster.(See INSTRUMENT CLUSTER.)
Operation
-
The illumination condition of the check fuel cap warning light is as follows:
-
DTC P0457:00 is stored (PCM detects that fuel cap is open)
-
Check fuel cap warning light illumination condition
-
The PCM sends a check fuel cap warning light illumination request to the instrument cluster via CAN communication.
Charging System Warning Light
Purpose, Function
Warns the driver of a charging system malfunction.
Construction
The charging system warning light is built into the instrument cluster..
Operation
...
Cruise Main Indicator Light (Amber)
Purpose/Function
Illuminates while the cruise control system is in standby mode to inform
the driver that the cruise control system is on standby.
Construction
Built into the in ...
Other materials:
Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection
CAUTION:
Resistance inspection using other testers may cause damage to the ABS wheel-speed
sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed
sensor.
1. Switch the ignition to off.
2. Connect the M-MDS to the DLC-2. ...
Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing
Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot
Monitoring (Bsm)]
Description
BSM indicator light does not flash while under BSM indicator light-flashing
conditions (with combination switch operation (turn signal switch))
The BSM indicator light does not flash or illuminate continuously,
but the cond ...
Neutral Switch Inspection
Continuity Inspection
1. Disconnect the negative battery cable..
2. Remove the neutral switch..
3. Inspect for continuity between neutral switch No.1 terminal A and B.
If not as specified, replace the neutral switch No.1..
Specification
Measured conditio ...
