Mazda CX-5 Service & Repair Manual: Cruise Main Indicator Light (Amber)
Purpose/Function
-
Illuminates while the cruise control system is in standby mode to inform the driver that the cruise control system is on standby.
Construction
-
Built into the instrument cluster.
Operation
-
Illuminates while the cruise control system is on standby.
-
The PCM sends a cruise main indicator light (amber) illumination request to the instrument cluster via CAN communication.
Check Fuel Cap Warning Light
Purpose/Function
The check fuel cap warning light is built into the instrument cluster.
If the PCM detects that the fuel cap is open, the light illuminates to warn
the driver that th ...
Cruise Set Indicator Light (Green)
Purpose/Function
Illuminates during the cruise control system operation to inform the driver
that the cruise control system is operating.
Construction
Built into the instrument ...
Other materials:
Rear Sash Molding Removal
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
1. Remove the rear door garnish. (rear side).
2. Remove the double-sided adhesive tape in the position shown in the figure
using the utility knife.
CAUTION:
...
Purge Solenoid Valve Inspection
Airflow Inspection
1. Disconnect the negative battery cable..
2. Remove the purge solenoid valve..
3. Inspect airflow between the ports under the following conditions.
Measured condition
Continuity between ports A—B
When voltage is not ...
Active Command Modes Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “BSML” or “BSMR”.
3. Select the simulation items from the PID table.
4. ...
