Mazda CX-5 Service & Repair Manual: Brake Fluid Inspection
1. Verify that the brake fluid level in the brake fluid reserve tank is between the MAX and MIN marks.
-
If the brake fluid level is below the MIN mark, add brake fluid.
Brake Fluid Air Bleeding
CAUTION:
Brake fluid will damage painted surfaces. Be careful not to spill any on
painted surfaces. If it is spilled, wipe it off immediately.
NOTE:
Keep the fluid level in th ...
Brake Fluid Pressure Sensor
Purpose/Function
The brake fluid pressure sensor detects the fluid pressure from the master
cylinder and transmits it to the DSC HU/CM.
Construction
The brake fluid pressure sen ...
Other materials:
Center Roof Antenna Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Front seat belt adjusting cover.
e. Front seat belt upper anchor installation bolt.
f. B-pillar upper trim.
g. Trunk board.
h. Trunk end t ...
Shift Solenoid No.3 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.3 adjusts the hydraulic pressure in the R-3-5 brake circuit
based on the current demand from the TCM according to the vehicle conditions.
Construction
Shift solenoid No.3 is installed to the solenoid control valve body.
Shift solenoid ...
Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Construction
A thermistor-type ambient temperature sensor has been adopted.
The ambient ...
