Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Magnetic Clutch Disassembly/Assembly [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Magnetic Clutch Disassembly/Assembly [Full Auto Air Conditioner]

1. Disassemble in the order indicated in the table.



1

Bolt

(See Bolt Removal/Installation Note.)

2

Pressure plate

3

Shim

(See Shim Installation Note.)

4

Snap ring

(See Snap Ring Removal/Installation Note.)

5

A/C compressor pulley

6

Snap ring

(See Snap Ring Removal/Installation Note.)

7

Stator

8

A/C compressor body


2. Assemble in the reverse order of disassembly.

3. Adjust the magnetic clutch clearance..

Bolt Removal/Installation Note

1. When removing or installing the bolt, lock the A/C compressor pulley against rotation using the following procedure.

CAUTION:

a. Apply battery positive voltage to the magnetic clutch terminal and connect the A/C compressor body to the ground.


b. Wrap the drive belt, which is no longer of use, tightly around the A/C compressor pulley.


c. Hold the drive belt in place with pliers.

d. Remove/installation the bolt.

2. When installing a new A/C compressor body, replace the recommended bolt.

Snap Ring Removal/Installation Note

1. Remove/install the snap ring using a snap ring pliers.


Shim Installation Note

1. First, insert the 1mm (0.039 in)

thick shim into the shaft.


Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify the clearance. If not within the specif ...

Magnetic Clutch Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the table. 1 Bolt (See Bolt Removal/Installation Note.) 2 Pressure plate 3 ...

Other materials:

Odometer/Tripmeter
Purpose The odometer/tripmeter notifies the user of the total travel distance or the traveled distance over a specific interval. Function The instrument cluster calculates the traveled distance based on the traveled distance signal from the PCM and displays it. The ...

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

Transfer Removal/Installation [Fw6 Ax EL]
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor (axle side) and ...

© 2016-2026 Copyright www.mcx5.org