Mazda CX-5 Service & Repair Manual: Brake Fluid Pressure Sensor

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake Fluid Pressure Sensor

Purpose/Function

The brake fluid pressure sensor detects the fluid pressure from the master cylinder and transmits it to the DSC HU/CM.

Construction

The brake fluid pressure sensor is built into the DSC HU/CM. Therefore if there is any malfunction of the brake fluid pressure sensor, replace the DSC HU/CM.

Fail-safe


DTC No.	Fail-safe function
C0044:01	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.) Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS* controls.
C0044:28	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.
C0044:54
C0044:64	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.) Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.

* Enabled depending on malfunction content.

Brake Fluid Inspection

1. Verify that the brake fluid level in the brake fluid reserve tank is between the MAX and MIN marks. If the brake fluid level is below the MIN mark, add brake fluid. ...

Brake Fluid Pressure Sensor Inspection

1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Other materials:

Clock Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Front console box. c. Shift panel. d. Upper panel. e. Rear console. f. Side wall. g. Decoration panel. h. Front console. i. Glove compartment. j. Climate control unit. 3. P ...

Throttle Body
Purpose, Function Opens/closes the throttle valve to adjust the amount of air supplied to the cylinder. Opens/closes the throttle valve according to the control signal from the PCM. Construction The throttle body is installed to the intake manifold. Th ...

Starter Interlock Switch [Skyactiv G 2.0]
Purpose, Function The starter interlock switch mechanism prevents vehicle surge when the engine is started, enhancing safety. The engine cannot be started unless the clutch is depressed. Construction The mechanism is provided with a starter interlock switch on the circuit ...