Mazda CX-5 Service & Repair Manual: Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
-
The ambient temperature sensor detects the ambient temperature.
Function
-
The ambient temperature sensor converts the detected temperature to an electric signal.
Construction
-
A thermistor-type ambient temperature sensor has been adopted.
-
The ambient temperature sensor is installed to the shroud panel on the back side of the front bumper.
Operation
-
The thermistor changes the resistance according to the surrounding temperature.
-
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.
Fail-safe
-
Function not equipped.
Ambient Temperature Sensor [Full Auto Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Co ...
Differential Oil Temperature Sensor
Purpose, Function
The differential oil temperature sensor detects the rear differential oil
temperature based on the resistance of the thermistor, and inputs it to the
AWD CM.
Const ...
Other materials:
A Pillar Trim Removal/Installation
1. Partially peel back the seaming welt.
2. Take the shaded area shown in the figure, and pull the A-pillar trim in the
direction of the arrow (1) while detaching clip A, clips B.
3. Cut the lead wire connecting clips B and grommet using a nipper.
4. Pull the A-pillar trim in the dir ...
Rear Oil Seal Replacement
1. Remove the transaxle..
2. Remove the flywheel (MTX) or the drive plate (ATX)..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
Rear oil seal
(See Rear Oil Seal Removal Note.)
(See Rear Oil Seal Installation Not ...
Keyless Warning Alarm
Purpose
The keyless warning alarm notifies the driver that the remote transmitter
cannot be verified or the steering lock cannot be released.
Function
When the instrument cluster receives the keyless warning alarm request signal
sent from the start stop unit via the CAN sig ...
