Mazda CX-5 Service & Repair Manual: Ambient Temperature Sensor [Full Auto Air Conditioner]
Purpose
-
The ambient temperature sensor detects the ambient temperature.
Function
-
The ambient temperature sensor converts the detected temperature to an electric signal.
Construction
-
A thermistor-type ambient temperature sensor has been adopted.
-
The ambient temperature sensor is installed to the shroud panel on the back side of the front bumper.
Operation
-
The thermistor changes the resistance according to the surrounding temperature.
-
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.
Fail-safe
-
Function not equipped.
Ambient Temperature Sensor Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Disconnect the connector.
4. Remove the ambient temperature sensor.
5. Install in the reverse order of removal. ...
Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Co ...
Other materials:
Fuel Gauge Sender Unit Removal/Installation [Awd]
WARNING:
Always keep sparks and flames away from fuel when servicing the fuel system.
Fuel can be easily ignited which could cause serious injury or death, and damage
to equipment.
Fuel line spills and leakage from the pressurized fuel system are dangerous.
Fuel can ignite a ...
Key Cylinder Switch
Purpose
The switch turns on/off in conjunction with the front door key cylinder lock/unlock
and the rear body control module (RBCM) detects the key cylinder operation condition
by the change in the voltage.
Function
The key cylinder switch contact point changes in conjuncti ...
Front Wheel Hub Bolt Replacement
1. Remove the brake calliper component from the steering knuckle and suspend
it out of the way using a cable.
2. Remove the disc plate.
3. Remove the wheel hub bolt using the SST as shown in the figure.
4. Place a new wheel hub bolt in the wheel hub.
5. Install the wheel hub by placi ...
