Mazda CX-5 Service & Repair Manual: ABS
- ABS Control
- ABS Wheel Speed Sensor And ABS Sensor Rotor
- Brake System/ABS Warning Light
- Front ABS Wheel Speed Sensor Inspection
- Front ABS Wheel Speed Sensor Removal/Installation
- Rear ABS Wheel Speed Sensor Inspection [2 Wd]
- Rear ABS Wheel Speed Sensor Inspection [Awd]
- Rear ABS Wheel Speed Sensor Removal/Installation
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
ABS Control
Outline
ABS control occurs when wheel slip is determined by the DSC CM (based on
the four ABS wheel-speed sensors). Then, the DSC HU inlet and outlet solenoid
valves are operated and brak ...
Other materials:
Front Body Control Module (Fbcm) Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
Rear Mount Camera Removal/Installation
CAUTION:
The audio unit communicates with the rear mount camera and records the presence/non-presence
of the rear mount camera when the ignition is switched to ACC or ON (engine
off or on) after connecting the negative battery cable.
If the commander switch is installed wit ...
Turn And Hazard Indicator Alarm
Purpose
The turn and hazard indicator alarm notifies the driver that a turn light
or the hazard warning lights are flashing.
Function
When the instrument cluster receives the turn signal/hazard warning indicator
light illumination request signal sent from the front body con ...
