Mazda CX-5 Service & Repair Manual: Ignition Switch, Steering Lock

Keyless Warning Alarm

Purpose The keyless warning alarm notifies the driver that the remote transmitter cannot be verified or the steering lock cannot be released. Function When the instrument cluste ...

Front Door Key Cylinder Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the service hole cover. 3. Detach the screw from the front door key cylinder. NOTE: The screw cannot be removed because the f ...

Other materials:

Remote Handle Lever Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. 3. Disconnect the remote cable on the remote handle lever side from the remote cable on the rear seat side. 4. Remove the remote c ...

Hazard Warning Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the decoration panel.. 3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table. If the continuity is as indicated in the table, go to the next step. If not as indicated i ...

Wiper And Washer Switch Removal/Installation
1. Switch the ignition ON (engine off or on). 2. Open the driver's door. 3. Switch the ignition OFF. 4. Disconnect the negative battery cable.. 5. Remove the column cover.. 6. Rotate the steering wheel in the direction of the arrow shown in the figure to the angle where the service h ...