Mazda CX-5 Service & Repair Manual: Cylinder Head Cover
Purpose, Function
-
The cylinder head cover prevents foreign material penetration and engine oil spatter.
-
The oil baffle plate reduces engine oil consumption by separating the engine oil from the blow-by gas.
Construction
-
The lightweight cylinder head cover is made of hard plastic with excellent noise absorption.
-
The cylinder head cover has the following parts:
Camshaft
Purpose, Function
The camshaft is rotated by receiving the rotation force of the crankshaft
via the timing chain. The valve is opened and closed according to the cam shape
at this time.
...
Cylinder Head Gasket Replacement
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
Fuel vapor is hazardous. It can very easily ignite, causing serious inj ...
Other materials:
High Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The high clutch operates in 4GR, 5GR, and 6GR and intermittently operates
the rear carrier by drive force from the turbine shaft.
For the high clutch, a centrifugal balance clutch has been adopted to prevent
clutch drag and to assure stabilized piston thrust in ...
Theft Deterrent Horn Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk end trim.
b. Rear scuff plate (RH).
c. Trunk side trim (RH).
d. Theft-deterrent horn.
3. Apply battery positive voltage to horn terminal A, and connect the horn retaining
bolt to ground as shown in the f ...
Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction
If the control valve body and oil pressure switch are replaced, always perform
the initial learning. If the initial learning is not completed, engine rev-up
may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial
learning has not been implement ...
