Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake Hose (Front) Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake Hose (Front) Removal/Installation

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage..



1

Brake pipe

2

Clip

3

Bolt

4

Brake hose


Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Brake Hose (Rear) Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. ...

Other materials:

Oil Pump [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pump generates hydraulic pressure in the oil line of the automatic transaxle together with supplying lubrication to powertrain related parts. Construction The oil pump has adopted a gear type with built-in outer and inner rotors. The inner roto ...

Differential Oil Replacement
1. Place the vehicle on level ground. 2. Remove the filler plug. 3. Remove the drain plug and drain the differential oil into a container. 4. Install a new washer and the drain plug, and tighten. Tightening torque 40—53 N·m {4.1—5.4 kgf·m, 30—39 ft·lbf} 5. Add the ...

Front Wiring Harness Protector Removal/Installation
Front Wiring Harness Protector No.1 1. Disconnect the negative battery cable.. 2. Remove the air cleaner case.. 3. While pressing the tabs of clip A in the direction of the arrows (1) shown in the figure, pull clip A in the direction of the arrow (2) shown in the figure to detach the tab of ...

© 2016-2026 Copyright www.mcx5.org