Mazda CX-5 Service & Repair Manual: Transfer Oil Inspection [Fw6 Ax EL]
1. Park the vehicle on level ground.
2. Remove the oil level plug with the washer.
3. Checking by hand, verify that the oil is near the brim of the plug hole.
-
If the oil level is low, add the specified amount and type of oil through the oil level plug hole.
-
Transfer oil
-
Specified oil grade: API Service GL?5
-
Specified oil viscosity: SAE 80W-90
-
Capacity (approx quantity): 0.45 L {0.48 US qt, 0.40 lmp qt}
4. Tighten the oil level plug with a new washer.
-
Tightening torque
-
40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}
Transfer
Purpose, Function
A transfer with simple, one-axis construction has been adopted for size and
weight reduction.
A thinner transfer case has been adopted for weight reduction.
C ...
Transfer Oil Replacement [Fw6 Ax EL]
1. Remove the front under cover No.2..
2. Remove the drain plug with the washer.
3. Drain the oil into a suitable container.
4. Tighten the drain plug with a new washer.
Tightening ...
Other materials:
Front Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the front
scuff plate in the direction of the arrow (1) shown in the figure, then detach the
hook B, clip C, and pin D while pulling in the direction of the arrow (2).
2. Take the shaded area shown in the figure, detach ta ...
Rear Shock Absorber Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
1
Rear shock absorber upper nut
(See Rear Shock Absorber Upper nut Installation Note.)
2
Rear shock absorber lower bolt
3
...
Air Intake Actuator [Manual Air Conditioner]
Purpose
The air intake actuator moves the air intake door in the blower unit to switch
the air intake port.
Function
The air intake actuator drives the motor based on the signal from the climate
control unit and moves the air intake door to the FRESH or REC position.
...
