Mazda CX-5 Service & Repair Manual: Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
-
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling the TCS control at driver discretion.
-
The TCS OFF indicator light, built into the instrument cluster, informs the driver that TCS control has been disabled by operation of the TCS OFF switch.
Operation
-
When the DSC system and CAN lines are functionally normally, the TCS OFF indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function.
-
When the TCS OFF switch is pressed to disable TCS control, the TCS OFF indicator light illuminates.
NOTE:
-
To inhibit the TCS control, continue to press the TCS OFF switch until the TCS OFF indicator light illuminates.
-
The TCS OFF indicator light illumination and TCS/DSC/roll over mitigation (ROM) control conditions while operating the TCS OFF switch are as indicated in the table.
|
TCS OFF indicator light illumination conditions |
TCS control conditions |
DSC control conditions |
Roll over mitigation (ROM) control conditions |
||
|
Brake control |
Engine control |
||||
|
TCS ON |
Not illuminated |
Permitted |
Permitted |
Permitted |
Permitted |
|
TCS OFF |
Illuminated |
Permitted |
Inhibited |
Permitted |
Permitted |
Fail-safe
|
DTC No. |
Fail-safe function |
|
C0089:64 |
|
Tcs Off Switch Removal/Installation
NOTE:
The TCS OFF switch is integrated with the cluster switch.
Refer to SWITCH PANEL REMOVAL/INSTALLATION to remove the cluster switch.
1. Remove the cluster switch from the swi ...
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
Other materials:
Rear Washer Nozzle Adjustment
CAUTION:
If the nozzle angle is adjusted with excessive force by strongly inserting
a needle or similar thin tool into the injection nozzle of rear washer nozzle,
it could damage the nozzle internally. When adjusting the nozzle, be careful
not to apply excessive force.
1. Inse ...
Air Bag System [Standard Deployment Control System]
Outline
The air bag system is a device that supplements the passenger restraint function
of the seat belts. The air bag system will not have the designed effect if the
seat belts are not worn properly.
The air bag system is composed of the following parts:
...
Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The oil pressure switch detects the engagement pressures of the low clutch,
2-6 brake, R-3-5 brake, and the high clutch.
The oil pressure switch signal is used for automatic shift control, manual
shift control, TCC control, line pressure control, direct electric ...
