Mazda CX-5 Service & Repair Manual: Speedometer

Mazda CX-5 Service & Repair Manual / Body / Driver Info & Control / Gauges / Speedometer

Purpose

The speedometer notifies the driver of the speed at which the vehicle is traveling.

Function

The instrument cluster controls the speedometer needle based on the vehicle speed signal from the PCM and displays the current vehicle speed.

Construction

An analog needle display speedometer with a stepping motor mechanism has been adopted.

Operation

The instrument cluster receives (1) the vehicle speed signal from the PCM when the ignition is switched ON (engine on).
The instrument cluster moves the needle based on the vehicle speed signal and displays (2) the current vehicle speed.

Fail-safe

Function not equipped.

Odometer/Tripmeter

Purpose The odometer/tripmeter notifies the user of the total travel distance or the traveled distance over a specific interval. Function The instrument cluster calculates the t ...

Tachometer

Purpose The tachometer notifies the driver of the engine speed. Function The instrument cluster controls the tachometer needle based on the engine speed signal from the PCM and ...

Other materials:

High Mount Brake Light Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the liftgate upper trim.. 3. Remove the rear spoiler.. 4. Disconnect the connector. 5. While pressing the high-mount brake light tab in the direction of arrow (1) shown in the figure, press the high-mount brake light in the direction ...

Refrigerant System Service Warnings
Handling Refrigerant Avoid breathing air conditioning refrigerant or lubricant vapor. Exposure may irritate eyes, nose and throat. Also, due to environmental concerns, we urge use of recovery/recycling/recharging equipment when draining HFC-134a from the air conditioning system. If a ...

Active Command Modes Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “BSML” or “BSMR”. 3. Select the simulation items from the PID table. 4. ...