Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Vanity Mirror Illumination Inspection

1. Disconnect the negative battery cable.. 2. Remove the sunvisor.. 3. Verify that the continuity between the vanity mirror illumination terminals is as indicated in the table. I ...

Light Switch Inspection

Light Switch 1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the light switch.. 4. Verify that the continuity between the light switch terminals is as indicate ...

Other materials:

Start Stop Unit Configuration (Using As Built Data)
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing th ...

Heated Oxygen Sensor (HO2 S) Removal/Installation
WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. CAUTION: Do not allow flammable objects such as the taping for bundling wiring harness to come into contact with the exhau ...

Relay And Fuse Block Disassembly/Assembly
1. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 2. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull up relay and fuse block No.1 in the direction of the arrow (2) shown in the figure, and de ...