Mazda CX-5 Service & Repair Manual: Rust Preventive Treatment [Water Proof And Rust Preventive]

Room Straight Line Dimensions (3) [Dimensions]

Point symbol Designation Hole diameter or bolt or nut size mm {in} A Rear seat installation hole ?14 {0.55} ...

Side Member Installation [Panel Replacement]

Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before inst ...

Other materials:

Tire Pressure Monitoring System Set Switch Inspection
1. Remove the TPMS set switch.. 2. Verify that the resistance between the TPMS set switch terminals B and C is as indicated in the table. If not as indicated in the table, replace the TPMS set switch. TPMS set switch specification Terminal ...

Front Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the front accessory socket i ...

Efficient Installation Of Body Panels
Checking Preweld Measurements And Watching Align to the standard reference dimensions, based upon the body dimensions illustration, so that new parts are installed in the correct position. Welding Notes For the number of weld points, welding should be performed in accord ...