Mazda CX-5 Service & Repair Manual: Resistor Inspection [Manual Air Conditioner]
1. Verify that the resistance between the resistor terminals is as shown in the table.
-
If there is any malfunction, replace the resistor.
|
Terminal |
Resistance (ohm) |
|
A—D |
0.35—0.41 |
|
A—B |
0.95—1.09 |
|
A—C |
2.68—3.08 |
Refrigerant System Service Warnings
Handling Refrigerant
Avoid breathing air conditioning refrigerant or lubricant vapor. Exposure
may irritate eyes, nose and throat. Also, due to environmental concerns, we
urge use of reco ...
Resistor Removal/Installation [Manual Air Conditioner]
NOTE:
When removing the resistor, perform the procedure in the posture shown in
the figure.
1. Disconnect the negative battery cable..
2. Remove the dashboard under cover..
...
Other materials:
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft
(primary gear).
The turbine/input shaft speed sensor and output shaft speed ...
Brake Fluid Air Bleeding
CAUTION:
Brake fluid will damage painted surfaces. Be careful not to spill any on
painted surfaces. If it is spilled, wipe it off immediately.
NOTE:
Keep the fluid level in the brake fluid reserve tank at 3/4 full or more
during the air bleeding.
Begin air bleedin ...
Spark Plug Removal/Installation [Skyactiv G 2.0]
CAUTION:
If a spark plug that is not as specified is installed, engine performance
will be deteriorated. Install only the specified spark plug when replacing.
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the ignition coils..
4. Remove th ...
