Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Resistor Removal/Installation [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Resistor Removal/Installation [Manual Air Conditioner]

NOTE:

1. Disconnect the negative battery cable..

2. Remove the dashboard under cover..

3. Disconnect the connector.


4. Rotate the resistor (2) while pressing the tab (1).


5. Remove the resistor.


6. Install in the reverse order of removal.

Resistor Inspection [Manual Air Conditioner]
1. Verify that the resistance between the resistor terminals is as shown in the table. If there is any malfunction, replace the resistor. Terminal ...

Resistor [Manual Air Conditioner]
Purpose The resistor controls the blower motor rotation speed. Function The resistor controls the supply voltage to the blower motor according to the fan switch operation, and a ...

Other materials:

DRL (Daytime Running Light) Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Disconnect the connector. 3. Rotate the DRL bulb in the direction of the arrow (1) shown in the figure and remove it from the front combination light in the direction of the arrow (2) shown in the figure. 4. Install in the reverse order ...

Front Frame (Rear) Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 33 locations shown in the figure. NOTE: When drilling, do not drill a hole all the way through or there could be a problem when installing the new part. 2. Remove the front frame (rear). ...

Front Crossmember Removal/Installation
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor wiring ha ...

© 2016-2026 Copyright www.mcx5.org