Mazda CX-5 Service & Repair Manual: Manual Air Conditioner Control System [Manual Air Conditioner]
Outline
-
The climate control unit performs the following controls based on the signals from each switch/dial and the sensor.
-
A/C compressor control
-
Defroster control
Block Diagram
Outline of Control System
-
Manual air conditioner has the following control.
|
Control name |
Control part |
|
Climate control unit |
A/C Compressor Control
-
The climate control unit sends the A/C signal to the PCM based on the signals sent from the A/C switch, airflow volume control dial, and evaporator temperature sensor.
-
The PCM turns the A/C relay on/off based on the input signals from the A/C signal and A/C pressure sensor and controls the A/C compressor (magnetic clutch) operation.
A/C signal on/off control
-
When the A/C switch and fan switch are turned on, the climate control unit turns the A/C signal (magnetic clutch) on/off based on the temperature of the air passing through the evaporator.
-
When the fan switch and A/C switch are turned on, the climate control unit controls the surface temperature of the evaporator so that it is within a certain range to prevent the evaporator from freezing.
-
When the ambient temperature is low, the climate control unit sets the A/C signal (magnetic clutch) off-temperature to low to prevent window fogging.
Defroster control
-
The defroster control improves the defrosting effect.
-
When the defroster switch turns on, the climate control unit fixes the air intake mode to FRESH.
-
The air intake is fixed at FRESH even if it has been set to REC manually.
Magnetic Clutch Inspection [Manual Air Conditioner]
1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor
body.
2. Verify that the magnetic clutch operates.
If there is any malfunction, replace the magnetic cl ...
Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor
and measure the resistance between passenger compartment temperature sensor terminals
A and B.
If the charact ...
Other materials:
Cooling System Cap Inspection
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may shoot out and cause serious injury. It may also damage
the engine and cooling system.
Tu ...
Up Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The up switch detects the shift up operation of the selector lever.
The up switch signal is sent to the TCM via CAN and is used for manual shift
control and engine-transaxle integration control.
Construction
The up switch is installed to the selector l ...
Manual Transaxle Operation
Manual Transaxle Shift Pattern
The shift pattern of the transaxle is conventional, as shown.
Depress the clutch pedal all the way down while shifting; then release it slowly.
Your vehicle is equipped with a device to prevent shifting to R (reverse) by
mistake.
Push the shift lever downward a ...
