Mazda CX-5 Service & Repair Manual: Manifold Absolute Pressure (Map) Sensor Inspection
Voltage Inspection
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification..
-
If not as specified, replace the MAP sensor/IAT sensor No.2..
Specification
Intake Manifold
Purpose, Function
Distributes intake air to each cylinder evenly.
Optimizes the combustion efficiency and performance of the engine by distributing
intake air to each cylinder.
...
Manifold Absolute Pressure (Map) Sensor
Purpose/Function
Detects the intake air pressure introduced into the cylinder as basic information
for mainly determining the fuel injection amount.
Detects the intake air pressure i ...
Other materials:
Front Seat Adjuster Unit Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both side ...
Tire Pressure Monitoring System Set Switch Inspection
1. Remove the TPMS set switch..
2. Verify that the resistance between the TPMS set switch terminals B and C is
as indicated in the table.
If not as indicated in the table, replace the TPMS set switch.
TPMS set switch specification
Terminal
...
Keyless Beeper Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the cowl grille..
3. Disconnect the connector.
4. Pull the keyless buzzer in the direction of the arrow (2) shown in the figure
while pressing the keyless buzzer tab in the direction of the arrow (1) shown in
the figure, detach the k ...
