Purpose
The Blind Spot Monitoring (BSM) warning alarm warns the driver of a possible accident.
Function
If the instrument cluster receives a warning sound request signal from the BSM control module (RH), it sounds the BSM warning alarm using the buzzer in the instrument cluster.
The BSM warning alarm sound pattern is as shown in the figure.

Construction
The BSM warning alarm sounds using the buzzer built into the instrument cluster.
Operation
The instrument cluster receives (1) the warning sound request signal from the BSM control module (RH).
The instrument cluster turns the transistor on (2) based on the warning sound request signal.
When the transistor turns on, a ground circuit with the alarm is established and the alarm sounds (3).

Fail-safe
Function not equipped.
Blind Spot Monitoring (Bsm) System
Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing
Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot
Monitoring (Bsm)]Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Side wall (driver-side).
b. Front heat duct (LH).
3. Disconnect the air mix actuator connector.
4. Remove the screw.
5. Remove the driver-side air mix actuator.
6. Install in the reverse order ...
Passenger Compartment Temperature Sensor [Full Auto Air Conditioner]
Purpose
The passenger compartment temperature sensor detects the cabin temperature.
Function
The passenger compartment temperature sensor converts the detected temperature
to an electric signal.
Construction
A thermistor-type passenger compartment temperature sens ...
Rear Center Seat Belt Removal/Installation
CAUTION:
The ELR (emergency locking retractor) has a spring that will unwind if the
retractor cover is removed. The spring cannot be rewound by hand. If this occurs,
the ELR will not work properly. Therefore, do not disassemble the retractor.
1. Press the release switch, then dis ...