Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Charcoal Canister Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Charcoal Canister Removal/Installation

U.S.A. And CANADA

1. Disconnect the negative battery cable..

2. Remove the floor under cover..

3. Remove in the order indicated in the table.



1

Quick release connector

(See QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2

Evaporative hose No.1

(See Evaporative hose No.1 installation note.)

3

Evaporative hose No.2

(See Evaporative hose No.2 installation note.)

4

CV solenoid valve connector

5

Fuel tank pressure sensor connector

6

Middle harness connector

7

Charcoal canister

(See Charcoal canister removal note.)

8

Charcoal canister bracket


4. Install in the reverse order of removal.

Charcoal canister removal note

1. Remove the charcoal canister, charcoal canister bracket as a single unit.

2. Remove the charcoal canister.

Evaporative hose No.2 installation note

1. Connect the evaporative hose No.2 as shown in the figure.


Evaporative hose No.1 installation note

1. Connect the evaporative hose No.1 as shown in the figure.


Except U.S.A. And CANADA

1. Remove the floor under cover..

2. Remove in the order indicated in the table.



1

Evaporative hose

(See Evaporative hose installation note.)

2

Charcoal canister

(See Charcoal canister removal note.)


3. Install in the reverse order of removal.

Charcoal canister removal note

1. Release the lock as shown in the figure.


2. Remove the charcoal canister.

Evaporative hose installation note

1. Connect the evaporative hose as shown in the figure.


Charcoal Canister Inspection
U.S.A. And CANADA Leakage inspection 1. Perform the following procedures: Do not operate CV solenoid valve. Assemble the hose used for inspection to port A. Cover ports B an ...

Charcoal Canister
Purpose, Function Absorbs evaporative gas flowing from the fuel tank to prevent release of the gas into the atmosphere. Construction The charcoal canister is installed near the ...

Other materials:

Forced Ignition On
NOTE: In order to perform a forced ignition ON, the M-MDS is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealership for instructions. The forced ignition ON procedure forces a power supply to each part when ...

Dynamic Stability Control (DSC)
The Dynamic Stability Control (DSC) automatically controls braking and engine torque in conjunction with systems such as ABS and TCS to help control side slip when driving on slippery surfaces, or during sudden or evasive maneuvering, enhancing vehicle safety. Refer to ABS  and TCS . DS ...

Instrument Cluster Removal/Installation
CAUTION: If configuration is not performed when the instrument cluster is replaced with a new one, the vehicle specification information is not stored in the instrument cluster and the system will not operate normally. When performing configuration, it is necessary to read the ...

© 2016-2026 Copyright www.mcx5.org