Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Electric Variable Valve Timing Control

Mazda CX-5 Service & Repair Manual / Engine / Control / Electric Variable Valve Timing Control

Outline

Block Diagram


Operation

Intake valve timing determination

Output duty ratio determination


Mode name

Control description

Control conditions

Feedback mode

  • Continuously monitors the intake valve timing if it matches the target intake valve timing determined according to the engine operation condition, and controls the output duty ratio based on the result.

  • Except for energization cut mode and phase holding mode

Energization cut mode

  • If there is any malfunction in the electric variable valve timing driver, the intake valve timing is held at the maximum retard position to stabilize the engine speed.

  • Electric variable valve timing driver malfunction

Phase holding mode

  • To improve the startability, the phase of the electric variable valve timing actuator is held at the intermediate position after the engine is stopped.

    Applied VIN (assumed): JM3 KE2*E*D# 100001?148106

  • After the engine is stopped (within a specified time)

    Applied VIN (assumed): JM3 KE2*E*D# 148107?

  • After the engine is stopped (Depending on the engine coolant temperature, operates after a certain period has elapsed from when the engine was stopped to suppress heating of the electrical variable valve timing motor.)


Driver Side Air Bag Module [Standard Deployment Control System]
Purpose When the driver-side air bag module receives an impact from a frontal or frontal offset collision, the operation (deployment) of the air bag mediates the impact to the head and fa ...

Electronic Control System Outline [Fw6 A EL, Fw6 Ax EL]
Outline In the electronic control system, the TCM calculates the control content based on signals from each type of sensor and switch to operate output parts such as each solenoid. In con ...

Other materials:

Clutch Disc Inspection [C66 M R]
Operation Inspection 1. Inspect the lining surface for discoloration and grease adhesion. 2. Inspect the torsion spring for weakness and the rivets for looseness. 3. Using a vernier caliper, measure the depth between the lining surface and the rivet head. Minimum clutch disc thicknes ...

Hood
Purpose/Function The hood is constructed with a large space between the front end of the hood and the engine to absorb an impact. Construction The hood stiffener positioned at the front end of the hood is shaped so that it collapses easily during an impact. In addition, the ...

Windshield Wiper Arm And Blade Adjustment
1. Switch the ignition ON (engine off or on). 2. Operate the windshield wiper at low speed. 3. Verify that the windshield wiper operates at low speed and stop the windshield wiper. 4. Verify that the windshield wiper stops at the auto-stop position. 5. Remove the windshield wiper arm and b ...

© 2016-2025 Copyright www.mcx5.org