Mazda CX-5 Service & Repair Manual: Disc Pad (Rear) Replacement
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, pump the brake pedal a few times and inspect the following:
-
The disc pad projection is securely installed to the piston groove
-
Parking brake lever stroke
-
Brake drag
|
1 |
Bolt |
|
2 |
Caliper (See REAR BRAKE (DISC) REMOVAL/INSTALLATION.) |
|
3 |
Disc pad |
|
4 |
Shim |
|
5 |
Guide plate |
Disc Pad (Front) Replacement
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, depress the brake pedal a few times, rotate the wheel
by hand, and verify that t ...
General Procedures (Brake)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
108—147 N ...
Other materials:
Outer Mirror Glass Inspection
Heated Outer Mirror
1. Disconnect the negative battery cable..
2. Remove the outer mirror glass..
3. Verify that the resistance and continuity between the heated outer mirror
terminals is as indicated in the table.
If not as indicated in the table, or if the resistance is not with ...
Specifications
Specifications
Engine
Electrical System
CAUTION
When cleaning the iridium plugs, do not use a wire brush. The fine particulate
coating on the iridium alloy and platinum tips could be damaged.
Lubricant Quality
NOTE
Refer to Introduction on for owner's responsibility in prot ...
Front Door Key Cylinder Switch Inspection
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door key cylinder.
d. Front door glass.
e. Front door module panel.
f. Front door latch and lock actuator.
Front Do ...
