Mazda CX-5 Service & Repair Manual: Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The automatic transaxle warning light illuminates when the transaxle has malfunction.
Construction
-
The automatic transaxle warning light is built into the instrument cluster.
Operation
-
If the transmission has a malfunction, the TCM sends an automatic transaxle warning light illumination request signal to the instrument cluster.
-
The TCM illuminates the automatic transaxle warning light for approx. 2 s
after the ignition is switched ON to perform a bulb check of the automatic transaxle warning light.
Air Bag System Warning Light [Two Step Deployment Control System]
Purpose
The air bag system warning light notifies the driver of a malfunction in
the SRS air bag system.
Function
If a malfunction occurs in the SRS air bag system, the air bag ...
Awd Warning Light
Purpose, Function
Warns the driver of a AWD system malfunction.
Construction
The AWD warning light is built into the instrument cluster.
Operation
If the self-di ...
Other materials:
Front Door Key Cylinder Switch Inspection
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door key cylinder.
d. Front door glass.
e. Front door module panel.
f. Front door latch and lock actuator.
Front Do ...
Front Beltline Molding Removal/Installation
CAUTION:
Affix protective tape to the position shown in the figure.
1. Fully open the front door glass.
2. Insert a tape-wrapped flathead screwdriver and then detach clips A in the
direction of arrow (1) shown in the figure.
3. Pull up the front side of front beltline molding ...
Front Body Control Module (Fbcm) Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
