Outline
The following glass has been adopted.
Windshield
Front door glass
Rear door glass
Rear door quarter glass
Quarter window glass
Rear window glass
Outer mirror glass
The following mirrors have been adopted.
Power outer mirror
Rearview mirror
Auto-dimming mirror (with auto-dimming mirror)
Rear window defroster has been adopted on the rear window glass.
Heated outer mirror has been adopted on the power outer mirrors. (with heated outer mirror system)
An auto-dimming mirror has been adopted on the rearview mirror. (with auto-dimming mirror)
UV protection glass has been adopted. (with UV protection glass)
Specification
Glass is thinner than for weight reduction.
Windshield: 4.5 mm
{0.18 in
}
Front door glass: 4.0 mm
{0.16 in
}
Rear door glass: 3.5 mm
{0.14 in
}
Rear door quarter glass: 3.1 mm
{0.12 in
}
Quarter window glass: 2.8 mm
{0.11 in
}
Rear window glass: 2.8 mm
{0.11 in
}
Structural view

Glass Antenna Inspection
Power Window Main SwitchRelay And Fuse Block
Purpose
Relays and fuses used by each system are grouped and housed together for
smooth inspection and replacement servicing.
Function
Relays and fuses used by each system are grouped and housed together.
Construction
Installed in the engine compartment.
...
Power Metal Oxide Semiconductor Field Effect Transistor (Power Mos Fet) Removal/Installation
[Full Auto Air Conditioner]
NOTE:
When removing the power MOS FET, perform the procedure in the posture shown
in the figure.
1. Disconnect the negative battery cable..
2. Remove the dashboard under cover..
3. Disconnect the connector.
4. Rotate the power MOS FET (2) while pressing the tab (1). ...
Seat Weight Sensor Calibration [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
calibration using the M-MDS.
Replacement with a new seat weight sensor
Replacement with a new seat weight sensor control module
Replacement with new passenger-side seat pa ...