Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Starter Removal/Installation [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Starting, Charging / Starter Removal/Installation [Skyactiv G 2.0]

WARNING:

1. Disconnect the negative battery cable..

2. Remove the front under cover No.2..

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Terminal B cable

2

Terminal S connector

3

Starter


Starter Interlock Switch [Skyactiv G 2.0]
Purpose, Function The starter interlock switch mechanism prevents vehicle surge when the engine is started, enhancing safety. The engine cannot be started unless the clutch is depressed. ...

Starter [Skyactiv G 2.0]
Purpose, Function The starter rotates the crankshaft via the ring gear and it serves as a trigger to start the engine. Construction The starter is installed to the rear part of ...

Other materials:

Controller Area Network (Can)
Outline The AWD control module (CM) sends and receives data to and from other modules via the CAN system. Refer to MULTIPLEX COMMUNICATION SYSTEM for a detailed explanation of the CAN system.. Data sent AWD system status Data received Engine speed Engin ...

Vanity Mirror Illumination Inspection
1. Disconnect the negative battery cable.. 2. Remove the sunvisor.. 3. Verify that the continuity between the vanity mirror illumination terminals is as indicated in the table. If not as indicated in the table, replace the sunvisor. ...

Front Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

© 2016-2026 Copyright www.mcx5.org